Havis C-VS-0809-CHGR-1 Manual

Consulte online ou descarregue Manual para Kits auto Havis C-VS-0809-CHGR-1. Havis C-VS-0809-CHGR-1 car kit Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 4
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
C-VS-0809-CHGR-1_INST_4-11
C-VS-0809-CHGR-1
(Assembly)
INSTALL INSTRUCTIONS C-VS-0809-CHGR-1
2011-2013 Dodge Charger (Police Package)
VEHICLE SPECIFIC CONSOLE
With 17” inches Equipment space
TOOLS NEEDED:
Phillips Screw Driver
Socket set (Standard & Metric)
Wire Cutters Wire Crimping tool
7/16 wrench T-20 Torx Bit
QTY DESCRIPTION PART #
1 Main Console Housing CM004345
CM004345 Main Housing Includes:
1 Floor Mount Bracket CM003956
1 Front / Center End Panel CM004380
1 Lighter Socket with cap CM216560
3 7/8” Plug CM86430
1 “O” Ring KRM98017
Not Included with CM00435 Housing, but included with complete kit:
1 Driver Side Trim Panel CM004381
1 Passenger Side Trim Panel CM004382
1 Lighter Socket with cap CM216560
1 Sensor Cover CM001638
1 Hardware kit C-HK-174
CM004380
Front / Center End Panel
CM004345
Main Console Housing
CM004381
Driver Side Trim Panel
CM003956
Floor Mount Bracket
ALWAYS!
*
Read all Instructions before installing any Havis, Inc. products.
*
Use Hardware included with install kit
CM004382
Passenger Side Trim Panel
NOTE:
If your vehicle has the optional carpet interior, there will be a small
hole in the carpet not covered by the console housing at the rear.
If desired, an optional cover plate part number - CM001642 is available.
Cover plate not shown.
Vista de página 0
1 2 3 4

Resumo do Conteúdo

Página 1 - VEHICLE SPECIFIC CONSOLE

C-VS-0809-CHGR-1_INST_4-11 C-VS-0809-CHGR-1 (Assembly) INSTALL INSTRUCTIONS C-VS-0809-CHGR-1 2011-2013 Dodge Charger (Police Package) VEHICLE SPECI

Página 2 - Passenger side

C-VS-0809-CHGR-1_INST_4-11 Remove O.E.M. plastic center console Remove Ignition proximity sensor / antenna from rear underside of O.E.M. console. (P

Página 3 - “O” Ring shown partially on

C-VS-0809-CHGR-1_INST_4-11 Cut off O.E.M 12 volt socket connectors and attach 1/4 spade connectors on O.E.M. wires. O.E.M. wire will need to be extend

Página 4 - C-VS-0809-CHGR-1_INST_4-11

C-VS-0809-CHGR-1_INST_4-11 A cover is provided to guard the O.E.M. Sensor on transmission hump. If desired, attach to existing stud and 6mm nut and w

Comentários a estes Manuais

Sem comentários